Gruvin Arts & Engineering uses dual-layer printed circuit boards to connect every component in the switch products. The boards are designed and manufactured to the highest commercial quality standards. No cross-talk, no noise, no capacitance, no intermittent connections. Using PCBs allows us to consistently produce the highest quality circuit in the lowest amount of time and cost.
We are building devices in miniature form factors. A jack or switch hole that misses the mark by even a few thousandths of an inch ends up in the scrap heap. Scrap enclosures increase cost. Gruvin Arts & Engineering enclosures are fabricated from 18 gauge cold rolled steel, punched and bent on state of the art CNC machinery. Every dimension is held flawlessly.
Our enclosures are finished in powder coating – the same powder used to protect floating weather towers adrift in the Indian Ocean. This finish will last a lifetime and will stand up to the harshest performance environments. Our fit and finish is superior to any hand-drilled aluminum enclosure.
When we spend our hard-earned money on tools for our music we want to be sure that we’re paying for the best design, proper assembly, professional fit and finish, high-quality components, and above all, flawless reliability and un-paralleled performance.
We warmly invite you to see for yourself the quality and performance of our products. If you are not satisfied with them for any reason, return them within 30 days of purchase for a full refund.
|
